This canless LED recessed light is IC rated, which is permitted to be in contact with insulations in ceilings, meaning the junction box is thermally protected. It only requires as small as 2 inches ceiling spaces, fits various ceilings, and joists. Recessed can is no longer a limitation for your choice.
The unique waterproof male and female connectors make it great for wet locations. The IC rating lets this light be in contact with insulation so you don't need to worry about it overheating and causing a fire.
Ultra-thin body, 5%-100% smooth dimming, compatible with most dimmers, suitable damp location, meets kinds of needs in applications such as kitchen, living room, bedroom, bathroom, workplace, common areas, outside soffits and other hard to reach spaces.
This light fits new construction, remodels, and retrofit installations. The aluminum light body extends the lifespan to 50,000hrs and the light comes backed by a 5-year warranty.
LED Ultra Slim Panel Light,led slim panel light,led slim panel,slim panel Rhein Lighting Technology Co.,Ltd. , https://www.rheinlighting.com
2 Change the engine oil. The new engine oil is usually neutral and will not corrode the metal parts of the engine.
3 Fill the fuel tank with diesel fuel to avoid rusting the fuel tank. Add preservatives if possible.
4 During the shutdown period, the engine should be started once a month to make the machine run at a short distance, so that a new oil film can be established at the lubrication part of each part to prevent rust. It should be noted that the cooling water should be filled before starting, and the cooling should be exhausted when finished. water.
2. Rebar bending machine should be parked in a dry room. If you have to park outdoors, you should choose a flat floor and put it on a wooden board. After parking, cover it with a cover cloth.
3, before long-term storage, the machinery must be maintained, repair damaged parts, and its thorough clean-up to maintain a good technical condition.
4. Arrangement and arrangement of the parking airport should ensure that the access of any machine is not affected by other machinery.
5. The mechanical fuel lever should be placed in the idle position, and the joysticks should be placed in the neutral position.
Rebar bending machine should pay attention to the problem of storage
1 Let go of the cooling water in the engine.